Repairing Water Damaged Hardwood Floors – Repair It Right the First Time

If you have experienced a flood recently, moved your dishwasher to find that it was leaking, or just been stuck with the bad luck of a leaking roof, then you may need to know about repairing water damaged hardwood floors. Many people attempt their own repairs in order to save themselves money, but in the end they end up costing themselves a fortune because they didn’t do it right the first time. With these tips, you can end up saving tons on labor by doing the project yourself. So how do you being repairing water damaged hardwood floors?

Tear Up the Water Damaged Portions Immediately

One of the first mistakes people make when repairing water damaged hardwood floors is that they let it sit and wait. Once that happens, the wood weakens and can become brittle, as can the support studs that are underneath the floor. If your hardwood has received water damage and it’s too late to save the wood, you need to tear up the damaged portions of the flooring immediately in order to prevent further damage.

If Your Flooring Is Wet, Your Subflooring Is Wet

The next mistake that many do it yourselfers make is that they take no consideration to their subflooring when they are repairing water damaged hardwood floors. If your hardwood floor has become wet enough that it needs to be replaced because it has caused damage, there is also going to be damage below the flooring as well. So not only are you going to need to tear up your hardwood floor, you are going to need to tear up your subflooring too.

Be Sure to Check Your Floor Supports

If you have a deck, take a look below it and see how the support studs are laid across. That is basically how all floors are constructed. When repairing water damaged hardwood floors, once you have the supports exposed, you need to first check for moisture, mold, and mildew. If there is any, make sure that it gets dried out and cleaned up immediately before replacing your floor. If your flooring supports are weak because of the water, you can strengthen them by installing two sister supports through the damaged beam. This step is one that many fail to consider and then they end up falling through a hole after they have repaired their floor.

The Whole Floor Doesn’t Have to Be Replaced

Many get frustrated when repairing water damaged hardwood floors because they feel that the look just isn’t quite right. Don’t replace the whole floor when all you need to do is patch it. No one but you will ever know the difference in the floor, and if you are really that irritated by the off pattern, you can always refinish the floor, which is much cheaper than an entire replacement.

If you need to be repairing water damaged hardwood floors, remember these tips to make sure that you get the job done right the first time and that you are saving as much money as you can.